heat-dashboard/devstack/plugin.sh
Eyal 49cffd1c18 support py3
manage.py should use the correct interpreter when installing
devstack

Change-Id: I78e352db36553ddfab8498efdf712aa806047fc5
2018-05-03 10:10:01 +03:00

63 lines
2.3 KiB
Bash

# plugin.sh - DevStack plugin.sh dispatch script heat-dashboard
HEAT_DASHBOARD_DIR=$(cd $(dirname $BASH_SOURCE)/.. && pwd)
function install_heat_dashboard {
# NOTE(shu-mutou): workaround for devstack bug: 1540328
# where devstack install 'test-requirements' but should not do it
# for heat-dashboard project as it installs Horizon from url.
# Remove following two 'mv' commands when mentioned bug is fixed.
mv $HEAT_DASHBOARD_DIR/test-requirements.txt $HEAT_DASHBOARD_DIR/_test-requirements.txt
setup_develop ${HEAT_DASHBOARD_DIR}
mv $HEAT_DASHBOARD_DIR/_test-requirements.txt $HEAT_DASHBOARD_DIR/test-requirements.txt
}
function configure_heat_dashboard {
cp -a ${HEAT_DASHBOARD_DIR}/heat_dashboard/enabled/* ${DEST}/horizon/openstack_dashboard/local/enabled/
cp -a ${HEAT_DASHBOARD_DIR}/heat_dashboard/local_settings.d/_1699_orchestration_settings.py ${DEST}/horizon/openstack_dashboard/local/local_settings.d/
cp -a ${HEAT_DASHBOARD_DIR}/heat_dashboard/conf/heat_policy.json ${DEST}/horizon/openstack_dashboard/conf/
# NOTE: If locale directory does not exist, compilemessages will fail,
# so check for an existence of locale directory is required.
if [ -d ${HEAT_DASHBOARD_DIR}/heat_dashboard/locale ]; then
(cd ${HEAT_DASHBOARD_DIR}/heat_dashboard; DJANGO_SETTINGS_MODULE=openstack_dashboard.settings $PYTHON ../manage.py compilemessages)
fi
}
# check for service enabled
if is_service_enabled heat-dashboard; then
if [[ "$1" == "stack" && "$2" == "pre-install" ]]; then
# Set up system services
# no-op
:
elif [[ "$1" == "stack" && "$2" == "install" ]]; then
# Perform installation of service source
echo_summary "Installing Heat Dashboard"
install_heat_dashboard
elif [[ "$1" == "stack" && "$2" == "post-config" ]]; then
# Configure after the other layer 1 and 2 services have been configured
echo_summary "Configuring Heat Dashboard"
configure_heat_dashboard
elif [[ "$1" == "stack" && "$2" == "extra" ]]; then
# no-op
:
fi
if [[ "$1" == "unstack" ]]; then
# no-op
:
fi
if [[ "$1" == "clean" ]]; then
# Remove state and transient data
# Remember clean.sh first calls unstack.sh
# no-op
:
fi
fi