:orphan: .. _cinder-backup-install: Install and configure the backup service ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Optionally, install and configure the backup service. For simplicity, this configuration uses the Block Storage node and the Object Storage (swift) driver, thus depending on the `Object Storage service `_. .. note:: You must :ref:`install and configure a storage node ` prior to installing and configuring the backup service. Install and configure components -------------------------------- .. note:: Perform these steps on the Block Storage node. .. only:: obs #. Install the packages: .. code-block:: console # zypper install openstack-cinder-backup .. end .. endonly .. only:: rdo #. Install the packages: .. code-block:: console # yum install openstack-cinder .. end .. endonly .. only:: ubuntu or debian #. Install the packages: .. code-block:: console # apt install cinder-backup .. end .. endonly 2. Edit the ``/etc/cinder/cinder.conf`` file and complete the following actions: * In the ``[DEFAULT]`` section, configure backup options: .. path /etc/cinder/cinder.conf .. code-block:: ini [DEFAULT] ... backup_driver = cinder.backup.drivers.swift backup_swift_url = SWIFT_URL .. end Replace ``SWIFT_URL`` with the URL of the Object Storage service, typically ``http://10.0.0.51:8080/v1/AUTH_`` if using the installation guide architecture. Finalize installation --------------------- .. only:: obs or rdo Start the Block Storage backup service and configure it to start when the system boots: .. code-block:: console # systemctl enable openstack-cinder-backup.service # systemctl start openstack-cinder-backup.service .. end .. endonly .. only:: ubuntu or debian Restart the Block Storage backup service: .. code-block:: console # service cinder-backup restart .. end .. endonly