71 lines
3.9 KiB
Python
71 lines
3.9 KiB
Python
# Copyright (C) 2017 Nippon Telegraph and Telephone Corporation.
|
|
#
|
|
# Licensed under the Apache License, Version 2.0 (the "License");
|
|
# you may not use this file except in compliance with the License.
|
|
# You may obtain a copy of the License at
|
|
#
|
|
# http://www.apache.org/licenses/LICENSE-2.0
|
|
#
|
|
# Unless required by applicable law or agreed to in writing, software
|
|
# distributed under the License is distributed on an "AS IS" BASIS,
|
|
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or
|
|
# implied.
|
|
# See the License for the specific language governing permissions and
|
|
# limitations under the License.
|
|
|
|
# Constants defined in netdevice(7)
|
|
|
|
# Interface flags
|
|
# from net/if.h
|
|
IFF_UP = 1 << 0 # Interface is running.
|
|
IFF_BROADCAST = 1 << 1 # Valid broadcast address set.
|
|
IFF_DEBUG = 1 << 2 # Internal debugging flag.
|
|
IFF_LOOPBACK = 1 << 3 # Interface is a loopback interface.
|
|
IFF_POINTOPOINT = 1 << 4 # Interface is a point-to-point link.
|
|
IFF_NOTRAILERS = 1 << 5 # Avoid use of trailers.
|
|
IFF_RUNNING = 1 << 6 # Resources allocated.
|
|
IFF_NOARP = 1 << 7 # No arp protocol, L2 destination address not set.
|
|
IFF_PROMISC = 1 << 8 # Interface is in promiscuous mode.
|
|
IFF_ALLMULTI = 1 << 9 # Receive all multicast packets.
|
|
IFF_MASTER = 1 << 10 # Master of a load balancing bundle.
|
|
IFF_SLAVE = 1 << 11 # Slave of a load balancing bundle.
|
|
IFF_MULTICAST = 1 << 12 # Supports multicast.
|
|
IFF_PORTSEL = 1 << 13 # Is able to select media type via ifmap.
|
|
IFF_AUTOMEDIA = 1 << 14 # Auto media selection active.
|
|
IFF_DYNAMIC = 1 << 15 # The addresses are lost when the interface goes down.
|
|
# from linux/if.h
|
|
IFF_LOWER_UP = 1 << 16 # Driver signals L1 up. (since Linux 2.6.17)
|
|
IFF_DORMANT = 1 << 17 # Driver signals dormant. (since Linux 2.6.17)
|
|
IFF_ECHO = 1 << 18 # Echo sent packets. (since Linux 2.6.25)
|
|
|
|
# Private interface flags
|
|
# from linux/netdevice.h
|
|
IFF_802_1Q_VLAN = 1 << 0 # 802.1Q VLAN device.
|
|
IFF_EBRIDGE = 1 << 1 # Ethernet bridging device.
|
|
IFF_BONDING = 1 << 2 # bonding master or slave.
|
|
IFF_ISATAP = 1 << 3 # ISATAP interface (RFC4214).
|
|
IFF_WAN_HDLC = 1 << 4 # WAN HDLC device.
|
|
IFF_XMIT_DST_RELEASE = 1 << 5 # dev_hard_start_xmit() is allowed to release skb->dst.
|
|
IFF_DONT_BRIDGE = 1 << 6 # disallow bridging this ether dev.
|
|
IFF_DISABLE_NETPOLL = 1 << 7 # disable netpoll at run-time.
|
|
IFF_MACVLAN_PORT = 1 << 8 # device used as macvlan port.
|
|
IFF_BRIDGE_PORT = 1 << 9 # device used as bridge port.
|
|
IFF_OVS_DATAPATH = 1 << 10 # device used as Open vSwitch datapath port.
|
|
IFF_TX_SKB_SHARING = 1 << 11 # The interface supports sharing skbs on transmit.
|
|
IFF_UNICAST_FLT = 1 << 12 # Supports unicast filtering.
|
|
IFF_TEAM_PORT = 1 << 13 # device used as team port.
|
|
IFF_SUPP_NOFCS = 1 << 14 # device supports sending custom FCS.
|
|
IFF_LIVE_ADDR_CHANGE = 1 << 15 # device supports hardware address change when it's running.
|
|
IFF_MACVLAN = 1 << 16 # Macvlan device.
|
|
IFF_XMIT_DST_RELEASE_PERM = 1 << 17 # IFF_XMIT_DST_RELEASE not taking into account underlying stacked devices.
|
|
IFF_IPVLAN_MASTER = 1 << 18 # IPvlan master device.
|
|
IFF_IPVLAN_SLAVE = 1 << 19 # IPvlan slave device.
|
|
IFF_L3MDEV_MASTER = 1 << 20 # device is an L3 master device.
|
|
IFF_NO_QUEUE = 1 << 21 # device can run without qdisc attached.
|
|
IFF_OPENVSWITCH = 1 << 22 # device is a Open vSwitch master.
|
|
IFF_L3MDEV_SLAVE = 1 << 23 # device is enslaved to an L3 master device.
|
|
IFF_TEAM = 1 << 24 # device is a team device.
|
|
IFF_RXFH_CONFIGURED = 1 << 25 # device has had Rx Flow indirection table configured.
|
|
IFF_PHONY_HEADROOM = 1 << 26 # the headroom value is controlled by an external entity. (i.e. the master device for bridged veth)
|
|
IFF_MACSEC = 1 << 27 # device is a MACsec device.
|