This patch makes the count of object replication failure in recon.
And "failure_nodes" is added to Account Replicator and
Container Replicator.
Recon shows the count of object repliction failure as follows:
$ curl http://<ip>:<port>/recon/replication/object
{
"replication_last": 1416334368.60865,
"replication_stats": {
"attempted": 13346,
"failure": 870,
"failure_nodes": {
"192.168.0.1": {"sdb1": 3},
"192.168.0.2": {"sdb1": 851,
"sdc1": 1,
"sdd1": 8},
"192.168.0.3": {"sdb1": 3,
"sdc1": 4}
},
"hashmatch": 0,
"remove": 0,
"rsync": 0,
"start": 1416354240.9761429,
"success": 1908
},
"replication_time": 2316.5563162644703,
"object_replication_last": 1416334368.60865,
"object_replication_time": 2316.5563162644703
}
Note that 'object_replication_last' and 'object_replication_time' are
considered to be transitional and will be removed in the subsequent
releases. Use 'replication_last' and 'replication_time' instead.
Additionaly this patch adds the count in swift-recon and it will be
showed as follows:
$ swift-recon object -r
========================================================================
=======
--> Starting reconnaissance on 4 hosts
========================================================================
=======
[2014-11-27 16:14:09] Checking on replication
[replication_failure] low: 0, high: 0, avg: 0.0, total: 0, Failed: 0.0%,
no_result: 0, reported: 4
[replication_success] low: 3, high: 3, avg: 3.0, total: 12,
Failed: 0.0%, no_result: 0, reported: 4
[replication_time] low: 0, high: 0, avg: 0.0, total: 0, Failed: 0.0%,
no_result: 0, reported: 4
[replication_attempted] low: 1, high: 1, avg: 1.0, total: 4,
Failed: 0.0%, no_result: 0, reported: 4
Oldest completion was 2014-11-27 16:09:45 (4 minutes ago) by
192.168.0.4:6002.
Most recent completion was 2014-11-27 16:14:19 (-10 seconds ago) by
192.168.0.1:6002.
========================================================================
=======
In case there is a cluster which has servers, a server runs with this
patch and the other servers run without this patch. If swift-recon
executes on the server which runs with this patch, there are unnecessary
information on the output such as [failure], [success] and [attempted].
Because other servers which run without this patch are not able to
send a response with information that this patch needs.
Therefore once you apply this patch, you also apply this patch to other
servers before you execute swift-recon.
DocImpact
Change-Id: Iecd33655ae2568482833131f422679996c374d78
Co-Authored-By: Kenichiro Matsuda <matsuda_kenichi@jp.fujitsu.com>
Co-Authored-By: Brian Cline <bcline@softlayer.com>
Implements: blueprint enable-object-replication-failure-in-recon
79ba4a8598