diff --git a/doc/build/latex/fuel-plugin-xenserver.pdf b/doc/build/latex/fuel-plugin-xenserver.pdf index 8ca1aba..a91818d 100644 Binary files a/doc/build/latex/fuel-plugin-xenserver.pdf and b/doc/build/latex/fuel-plugin-xenserver.pdf differ diff --git a/doc/source/guide.rst b/doc/source/guide.rst index 28acc59..421e592 100644 --- a/doc/source/guide.rst +++ b/doc/source/guide.rst @@ -60,6 +60,11 @@ Select Environment #. Add new VMs to the new environment according to `Fuel User Guide `_ and configure them properly. A typical topology of 3 controller nodes + 3 compute nodes + 1 storage node is recommended. +#. Check the MAC address of the networks assigned in the "Interface Configuration" + tab correspond to the correct physical or virtual interface. + Note that no networks should be assigned to the HIMN interface on compute nodes, + which will normally show as the last interface for these nodes. + #. Go to Settings tab and "Compute" section. You need to input the common access credentials to all XenServers that previously are used to create new VMs. .. image:: _static/fmsetting00.png