deb-murano/doc/source/install/configure_network.rst

Network Configuration

Murano may work in various networking environments and is capable to detect the current network configuration and choose the appropriate settings automatically. However, some additional actions are required to support advanced scenarios.

Nova network support

Nova Network is simplest networking solution, which has limited capabilities but is available on any OpenStack deployment without the need to deploy any additional components.

When a new Murano Environment is created, Murano checks if a dedicated networking service (i.e. Neutron) exists in the current OpenStack deployment. It relies on Keystone's service catalog for that. If such a service is not present, Murano automatically falls back to Nova Network. No further configuration is needed in this case, all the VMs spawned by Murano will be joining the same Network.

Neutron support

If Neutron is installed, Murano enables its advanced networking features that give you ability to not care about configuring networks for your application.

By default it will create an isolated network for each environment and join all VMs needed by your application to that network. To install and configure application in just spawned virtual machine Murano also requires a router connected to the external network.

Automatic Neutron network configuration

To create router automatically, provide the following parameters in config file:

[networking]

external_network = %EXTERNAL_NETWORK_NAME%
router_name = %MURANO_ROUTER_NAME%
create_router = true

To figure out the name of the external network, perform the following command:

neutron net-external-list

During the first deploy, required networks and router with specified name will be created and set up.

Manual neutron network configuration

• Step 1. Create public network

• First, you need to check for existence of external networks. Login as admin and go to Project -> Network -> Network Topology. And check network type in network details at Admin -> Networks -> Network name page. The same action can be done via CLI by running neutron net-external-list. To create new external network examine OpenStack documentation.

• Step 2. Create local network

• Go to Project -> Network -> Networks.
• Click Create Network and fill the form.

• Step 3. Create router

• Go to Project -> Network -> Routers
• Click "Create Router"
• In the "Router Name" field, enter the murano-default-router

If you specify a name other than murano-default-router, it will be necessary to change the following settings in the config file:

[networking]

router_name = %SPECIFIED_NAME%
create_router = false

• Click on the specified router name
• In the opened view click “Add interface”
• Specify the subnet and IP address

And check the result in Network Topology tab.