Add LVM2/iSCSI documentation

This patch adds to cinder-guide.rst LVM2/iSCSI related
information.

TrivialFix

Change-Id: I2c7b3090bbf314dd1281ca3d02148490936d5b86
This commit is contained in:
Serguei Bezverkhi 2016-04-02 15:56:05 -04:00
parent 7ab705cd4d
commit 07a5bd9db5

View File

@ -75,3 +75,60 @@ Check the console log added the disk:
A /dev/vdb should appear in the console log, at least when booting cirros.
If the disk stays in the available state, something went wrong during the
iSCSI mounting of the volume to the guest VM.
Cinder LVM2 backend with iSCSI
------------------------------
As of Newton-1 milestone, Kolla supports LVM2 as cinder backend. It is
accomplished by introducing two new containers tgtd and iscsid.
tgtd container serves as a bridge between cinder-volume process and a server
hosting Logical Volume Groups (LVG). iscsid container serves as a bridge
between nova-compute process and the server hosting LVG.
There are two methods to apply new configuration to cinder:
1 - New deployments: create cinder.conf and place it at /etc/kolla/config
folder, then add below configuration lines and run kolla deloyment.
2 - Existing cinder deployments: modify cinder.conf located at
/etc/kolla/config by adding below configuration lines and run kolla
reconfigure.
::
[DEFAULT]
enabled_backends = {local_lvm_name}
volume_name_template=volume-%s
[{local_lvm_name}]
lvm_type = default
volume_group = {lvg_name}
volume_driver = cinder.volume.drivers.lvm.LVMVolumeDriver
volume_backend_name = {local_lvm_name}
iscsi_helper=tgtadm
iscsi_ip_address={management_ip_address_of_server_hosting_LVG}
iscsi_protocol=iscsi
::
Where:
- local_lvm_name is a name chosen by a user for a spefic LVM2 backend, multiple
LVM2 backend can be confiugred and each should have a unique name.
- lvg_name is a name Logical Volume Group created for cinder to store volumes.
- management_ip_address_of_server_hosting_LVG is IP address of an interface
where cinder process is bound to. (Do not use VIP address here, LVG does not
move from server to server as VIP address does in case of a server failure).
NOTE: For Ubuntu and LVM2/iSCSI
iscsd process uses configfs which is normally mounted at /sys/kernel/config to
store discovered targets information, on centos/rhel type of systems this special
file system gets mounted automatically, which is not the case on debian/ubuntu.
Since iscsid container runs on every nova compute node, the following steps must
be completed on every Ubuntu server targeted for nova compute role.
1 - Add configfs module to /etc/modules
2 - Rebuild initramfs using: "update-initramfs -u" command
3 - Make sure configfs gets mounted during a server boot up process. There are
multiple ways to accomplish it, one example is adding this command to
"mount -t configfs configfs /sys/kernel/config" to /etc/rc.local