76c6c0f2e6
The tag_svn_revision option was already removed[1]. The values set to the other two options are effectively same as their defaults. [1] https://github.com/pypa/setuptools/issues/619 Change-Id: If69a8a10e8bc410974ea2d31be21fab7ec103477 |
||
|---|---|---|
| os_refresh_config | ||
| releasenotes/notes | ||
| tests | ||
| zuul.d | ||
| .coveragerc | ||
| .gitignore | ||
| .gitreview | ||
| .stestr.conf | ||
| LICENSE | ||
| README.rst | ||
| requirements.txt | ||
| setup.cfg | ||
| setup.py | ||
| test-requirements.txt | ||
| tox.ini | ||
Team and repository tags
os-refresh-config
os-refresh-config uses dib-run-parts to run scripts in a pre-defined set of directories:
/opt/stack/os-config-refresh/pre-configure.d
/opt/stack/os-config-refresh/configure.d
/opt/stack/os-config-refresh/post-configure.d
/opt/stack/os-config-refresh/migration.d
/opt/stack/os-config-refresh/error.d/opt/stack/os-config-refresh is the default base directory. You can set OS_REFRESH_CONFIG_BASE_DIR environment variable to override the default one.
Its intended purpose is to separate scripts execution into 4 phases:
- Quiesce(pre-configure.d),
- Configure(configure.d),
- Activate(post-configure.d).
- Migrate(migration.d),
It runs through all the phases above to ensure configuration is applied and enabled on a machine. It will run the scripts in error.d and then exit with a non-zero exit status if any phase has a problem. The scripts in each phase should not depend on each other having worked properly.
Note: Earlier versions of os-refresh-config ran migration before post-configure. This was an oversight in the initial design, as migrations are intended to be online migrations after the host is fully configured.
For things which must happen while the service is quiesced, that should be done in the post-configure scripts which control the service state.