starlingx/docs
Code Issues Proposed changes
Files
11ded0cf7ea0563cfd4ce35214b76d1376e067c9
docs/doc/source/fault/enabling-snmp-support.rst
Stone 10e4b9ac86 Fault Management guide 
Removed OSX and MS Visual Code metadata files and directories.

Change-Id: I4e6024767cc072fcb3fc8d88f0724f02819cebc8
Signed-off-by: Stone <ronald.stone@windriver.com>
2020-11-09 13:58:05 -05:00

792 B
Raw Blame History

Enable SNMP Support

SNMP support must be enabled before you can begin using it to monitor a system.

In order to have a workable SNMP configuration you must use the command line interface on the active controller to complete the following steps.

  1. Define at least one SNMP community string.

    See : Adding an SNMP Community String Using the CLI <adding-an-snmp-community-string-using-the-cli> for details.

  2. Configure at least one SNMP trap destination.

    This will allow alarms and logs to be reported as they happen.

    For more information, see Configuring SNMP Trap Destinations <configuring-snmp-trap-destinations>.