a3f09bf30c
This is useful when interface comes without any ip configured, so it is down and cannot be used. Change-Id: Ic930245ff5a8dbcc50d46858fc0c1f3d8a98fa7d
2.4 KiB
Deploying with libvirt
In order to deploy bifrost with libvirt, but managing baremetal servers, a special network config needs to be setup.
Two networks need to be created:
- default network, that will be a standard virtual network, using NAT.
- provisioning network, that will be used for PXE boot. As we need to setup a dhcp server on bifrost guest, creating a virtual network will give conflicts between guest and host. So to avoid it, we can define a network that uses macvtap interfaces, associated with the physical interface. Please note that you will need to have macvlan enabled on your kernel.
When creating the guest, a minimum of 8GB of memory is needed in order to build disk images properly. Also when defining the interfaces for the guest, the two networks that have been created need to be attached.
These sample commands will spin up a bifrost vm based on centos:
virsh net-define --file network/default.xml virsh net-start default virsh net-define --file network/br_direct.xml virsh net-start br_direct virsh define --file vm/baremetal.xml virsh start baremetal virsh console baremetal
When you login into baremetal, the interface for the provisioning network will be down. You may need to add an IP manually:
ip addr add <<provisioning_ip_address>>/<> dev <> ip link set <> up
Where to get guest images
In order to create the guest VMs, you will need a cloud image for the distro you want to deploy. You will need to download the guest image on a directory on the host, and then in the template for the VM, you can specify it on the disk section, as shown in the example template.
Please follow the information on this link to get the images:
http://docs.openstack.org/image-guide/obtain-images.html
Add credentials to guest image
Normally guest images come without user and password, they rely on ssh to allow access. In this case, it can be useful to enable ssh access to some user from host to guest. A way to do that, is creating a config drive and reference it on the template for the guest VM.
A useful script to generate config drives can be found at:
https://github.com/larsks/virt-utils/blob/master/create-config-drive
Relying on this script, a config drive can be created with:
create-config-drive -k ~/.ssh/id_rsa.pub config.iso
And then this ISO can be referenced on the guest VM template.