openstack-ansible/deploy-guide/source/app-config-prod-ceph.rst

Appendix D: Example Ceph production environment configuration

Introduction

This appendix describes an example production environment for a working OpenStack-Ansible (OSA) deployment with high availability services and using the Ceph backend for images, volumes, and instances.

This example environment has the following characteristics:

• Three infrastructure (control plane) hosts with ceph-mon containers
• Two compute hosts
• Three Ceph OSD storage hosts
• One log aggregation host
• Multiple Network Interface Cards (NIC) configured as bonded pairs for each host
• Full compute kit with the Telemetry service (ceilometer) included, with Ceph configured as a storage back end for the Image (glance), and Block Storage (cinder) services
• Internet access via the router address 172.29.236.1 on the Management Network

Network configuration

Network CIDR/VLAN assignments

The following CIDR and VLAN assignments are used for this environment.

Network	CIDR	VLAN
Management Network	172.29.236.0/22	10
Tunnel (VXLAN) Network	172.29.240.0/22	30
Storage Network	172.29.244.0/22	20

IP assignments

The following host name and IP address assignments are used for this environment.

Host name	Management IP	Tunnel (VxLAN) IP	Storage IP
lb_vip_address	172.29.236.9
infra1	172.29.236.11
infra2	172.29.236.12
infra3	172.29.236.13
log1	172.29.236.14
compute1	172.29.236.16	172.29.240.16	172.29.244.16
compute2	172.29.236.17	172.29.240.17	172.29.244.17
osd1	172.29.236.18	172.29.240.18	172.29.244.18
osd2	172.29.236.19	172.29.240.19	172.29.244.19
osd3	172.29.236.20	172.29.240.20	172.29.244.20

Host network configuration

Each host will require the correct network bridges to be implemented. The following is the /etc/network/interfaces file for infra1.

Note

If your environment does not have eth0, but instead has p1p1 or some other interface name, ensure that all references to eth0 in all configuration files are replaced with the appropriate name. The same applies to additional network interfaces.

../../etc/network/interfaces.d/openstack_interface.cfg.prod.example

Deployment configuration

Environment layout

The /etc/openstack_deploy/openstack_user_config.yml file defines the environment layout.

The following configuration describes the layout for this environment.

../../etc/openstack_deploy/openstack_user_config.yml.prod-ceph.example

Environment customizations

The optionally deployed files in /etc/openstack_deploy/env.d allow the customization of Ansible groups. This allows the deployer to set whether the services will run in a container (the default), or on the host (on metal).

For this environment, the cinder-volume runs in a container on the infrastructure hosts. To achieve this, implement /etc/openstack_deploy/env.d/cinder.yml with the following content:

../../etc/openstack_deploy/env.d/cinder-volume.yml.container.example

User variables

The /etc/openstack_deploy/user_variables.yml file defines the global overrides for the default variables.

For this environment, implement the load balancer on the infrastructure hosts. Ensure that keepalived is also configured with HAProxy in /etc/openstack_deploy/user_variables.yml with the following content.

../../etc/openstack_deploy/user_variables.yml.prod-ceph.example