openstack/openstack-manuals
Code Issues Proposed changes
e1943b01e1
openstack-manuals/doc/install-guide/source/cinder-backup-install.rst
Yushiro FURUKAWA 0019cedb4e Replace 'apt-get' to 'apt' 
'apt-get' is more primitive command than 'apt'. In addition, 'apt' is
the most recommended interface.[1]

[1]https://debian-handbook.info/browse/stable/sect.apt-get.html

Change-Id: I40dd27f3856a84f936236679cd0201b079a2172e
2016-11-07 02:06:05 +00:00

2.1 KiB
Raw Blame History

orphan

Install and configure the backup service

Optionally, install and configure the backup service. For simplicity, this configuration uses the Block Storage node and the Object Storage (swift) driver, thus depending on the Object Storage service.

Note

You must install and configure a storage node <cinder-storage> prior to installing and configuring the backup service.

Install and configure components

Note

Perform these steps on the Block Storage node.

obs

  1. Install the packages:

    # zypper install openstack-cinder-backup

rdo

  1. Install the packages:

    # yum install openstack-cinder

ubuntu or debian

  1. Install the packages:

    # apt install cinder-backup
  1. Edit the /etc/cinder/cinder.conf file and complete the following actions:

    • In the [DEFAULT] section, configure backup options:

      [DEFAULT]
...
backup_driver = cinder.backup.drivers.swift
backup_swift_url = SWIFT_URL

      Replace SWIFT_URL with the URL of the Object Storage service, typically http://10.0.0.51:8080/v1/AUTH_ if using the installation guide architecture.

Finalize installation

obs or rdo

Start the Block Storage backup service and configure it to start when the system boots:

# systemctl enable openstack-cinder-backup.service
# systemctl start openstack-cinder-backup.service

ubuntu or debian

Restart the Block Storage backup service:

# service cinder-backup restart